This Capcom Service Bulletin applies to:
Breakshot Pinball

Back to all Capcom Pinball Service Bulletins

COIN-OP, INC.
(Pinball Division is out of business)

REFERENCE: †††††††††††††††††††††††††† BREAKSHOT POWER DRIVER PCB MISWIRE

PART NUMBER:††††††††††††††††††††††† A0017704†††††††††

AFFECTED GAME SNíS:†††††††††† [1000479 THROUGH 10000617] AND [2002271 THROUGH 2002278]

DEAR DISTRIBUTOR,

IF EITHER THE F9 OR THE F10 FUSE ON THE POWER DRIVER PCB IS BAD, AND THE OTHER OF THE TWO FUSES IS STILL GOOD, BOTH FUSE LEDS WILL REMAIN LIT.THIS IS DUE TO THE DIODE TIE BACKS BEING CROSSED.THIS DOES NOT AFFECT THE GAME IN REGARDS TO FUNCTIONALITY, BUT CAN CAUSE CONFUSION WHEN TRYING TO TROUBLESHOOT.

TO REMEDY PERFORM THE FOLLOWING ON THE POWER DRIVER PCB:

* TURN POWER OFF.

* REMOVE THE VIOLET/BLUE WIRE AT PIN 6 OF CONNECTOR J16.

* REMOVE THE VIOLET/ORANGE WIRE AT PIN 3 OF CONNECTOR J16.

* INSERT THE VIOLET/BLUE WIRE INTO PIN 9 OF CONNECTOR J19.

* INSERT THE VIOLET/ORANGE WIRE INTO PIN 8 OF CONNECTOR J19.

 

IF YOU HAVE ANY QUESTIONS PLEASE CONTACT THE FIELD SERVICE DEPARTMENT.

THANK YOU.